Why do strands escape when an ultrasonic wire-harness terminal welding machine welds a harness terminal?


Nov 19,2026

Ultrasonic wire-harness terminal welding uses high-frequency vibration and pressure to form a solid-state bond between the copper strands and the terminal. Strand escape means that after welding part of the strands leave the weld zone and spread to the outside of the terminal or to its edges. The causes lie mostly in the condition of the harness end, the fit between terminal and fixture, the transfer of pressure and vibration, and the condition of the equipment itself.

I. Condition of the harness end

1. The end is not shaped or is insufficiently shaped and the bundle itself is loose, so the outer strands slide sideways first during vibration.

2. The stripped length is too long or too short, the strands do not fall fully inside the weld zone, and the overflowing part is pressed out at the edge.

3. The strands have kinks, oxidation or uneven tinning, so locally they can hardly bond with adjacent strands and gradually separate during vibration.

II. Fit between terminal and fixture

1. The width of the terminal crimp slot does not match the harness cross-section, the space inside the slot is too large, and the strands float during vibration.

2. The fixture clamping position is offset and the harness is not centred, so strands on one side overflow the area acted on by the welding horn.

3. The surfaces of the horn and anvil are uneven and the clearance is irregular, so pressure distribution leans to one side and squeezes the strands to the edge.

III. Transfer of pressure and vibration

1. Pressure is too low, contact between the strands is insufficient, vibration energy is not transferred fully, and the outer strands gradually loosen.

2. Pressure is too high or applied too fast, and the strands are crushed and squeezed out on both sides.

3. Welding time or amplitude is too large, the strands soften excessively and break by fatigue, scattering outside the terminal.

IV. Equipment and consumable condition

1. The tooth surface of the horn is worn and covered with copper pickup, grip force drops, and the strands slip during vibration.

2. The coaxiality and parallelism of the horn and anvil deviate, so the applied force is unevenly distributed.

3. The transducer and booster age, and the amplitude output becomes unstable, sometimes strong and sometimes weak.

V. Inspection and improvement directions

1. Shape the incoming ends properly, control the stripped length, and sample-check bundle looseness.

2. Select terminals and crimp slots that match the harness cross-section, and have the fixture keep the harness centred.

3. Check the horn tooth surface and anvil flatness regularly, calibrate coaxiality and parallelism, and watch whether the amplitude output is stable.

4. Observe where the strands escape: overflow on one side is mostly related to centring and pressure distribution, while scattering on all sides is mostly related to insufficient pressure or abnormal amplitude.

Wuxi Haifei Intelligent Equipment Co., Ltd. official website: https://www.haifeiwelder.com/

Wuxi Haifei Intelligent Equipment Co., Ltd. has been dedicated to the research and production of ultrasonic wire harness terminal welding machines for 17 years. The company has passed the ISO9001 quality management system certification, the national 3C certification and the CE certification. It is a national high-tech enterprise, a Specialized, Refined, Distinctive and Innovative enterprise of Jiangsu Province, a Specialized, Refined, Distinctive and Innovative enterprise of Wuxi City, and a Gazelle enterprise of the Southern Jiangsu National Independent Innovation Demonstration Zone. If you are interested in our ultrasonic wire harness terminal welding machines, please contact us: liuyiyu@jshaifei.com